Cardo G4 manual Contents of the Retail BOX, Charging the Headset

2.  CONTENTS OF THE RETAIL BOX

2 Helmet clamps (subject to the version purchased: Boom-Mounted or Cord-Mounted Microphone)

Two speakers

MP3 Jack

Noise(back of clamp) canceling

microphone

Sliding Panel

Flexible Boom

2 scala rider G4 headsets

Volume Up /		Flip-up
		antenna
Forward	Mobile Volume
Button
	Phone	Down /
	Button	Rewind

Button

		Silicone cover
Channel A		Charging Jack
Button		& Firmware
• Connect to
		download port
Rider A	LED	Channel B Button
• MP3 Button		• Connect to Rider B
		• FM Radio Button

2 Wall charger plugs

2 USB adapter cables

2 Allen wrenches

4 Velcro pads

2 MP3 cables

2 Glue plates

2Pre-moistened towlettes

2Carry pouches

4 Microphone sponges

Flat sponges for full-face helmets and round sponges for other helmet types

User Guide, stickers, Warranty and Registration form

The scala rider G4 is also available in a cord-mounted microphone version to better fit certain full-faced helmets with tight chin sections

IMPORTANT:

Your headsets are water-resistant, designed for use under moderate rain or snow conditions. The cover lid protecting the Charging Jack should be kept tightly closed at all times to prevent moisture from entering the device.

NOTE: WHILE MOST INSTRUCTIONS ON THIS MANUAL REFER TO THE HEADSET IN SINGULAR, THEY APPLY TO BOTH UNITS UNLESS INDICATED OTHERWISE

3. CHARGING THE HEADSET

Make sure that your headset is fully charged for at least four hours before initial use. Open the silicone cover protecting the Charging jack and Firmware download port.

Insert the USB cable to the wall charger and insert the other end of the cable to the headset’s Charging Jack. While charging, the Red Light turns on. When charging is complete, the Red Light will turn off.

4 scala rider® G4™ PowerSet