Manuals / Carrier / Power Tools / Air Compressor

Carrier 06D specifications 07D Condensing Unit Dimensions, DIMENSIONS in

Models: 06D

1 20

Download 20 pages 37.93 Kb

Page 2

DIMENSIONS (in.)

DIMENSIONS (in.)

UNIT 07D	WIDTH A
A203	30
B205	30
A208	399/16
B210	519/16
B212	519/16
B215	6313/16

NOTES:

1. For standard service practices, such as trouble- shooting and refrigerant charging, allow a minimum 2′-6″clearance around the unit.

2. Recommended service space for condenser tube removal is one condenser length at either end.

3. For compressor removal, allow a minimum 3′ wide access aisle to and from the unit.

4. Local codes or jurisdiction may prevail for unit clearances.

WATER CONNECTIONS FOR 07DB215 UNIT ONLY.

Fig. 1 — 07D Condensing Unit Dimensions

2

Image 2

Carrier 06D specifications 07D Condensing Unit Dimensions, DIMENSIONS in, WATER CONNECTIONS FOR 07DB215 UNIT ONLY

Contents

SAFETY CONSIDERATIONS CONTENTSBEFORE INSTALLATION INSTALLATIONWATER CONNECTIONS FOR 07DB215 UNIT ONLY Fig. 1 - 07D Condensing Unit DimensionsDIMENSIONS in 3. Local codes or jurisdiction may prevail for unit clearances Fig. 2 - 06D Compressor Unit Dimensions1. For standard service practices, such as trouble Electrical Connections Table 1 - Compressor Electrical DataFig. 3 - Unit Label Diagram - 06D,07D Units Oil Pressure Switch Fig. 4 - Compressor Terminal DiagramFig. 5 - 06D/07D Control Box Components and Connections 3-Phase Fig. 6 - Recommended Field Wiring CHECKING OPERATION Refrigerant ChargingINITIAL START-UP CAPACITY CONTROL Suction Cutoff Type Fig. 7 - Capacity Control Valve Pressure Type CONDENSER MAINTENANCECapacity Control Pressure Fig Table 4 - Capacity Control Reduction StepsFig. 11 - Compressor Fig. 10 - Forced Circulation Fig. 8 - Capacity Control Valve OperationFig. 9 - Gravity Circulation Bottom Plate RemovedTable 5 - Torque Values SERVICEService Notes Fig. 11 - Compressor Bottom Plate RemovedPHASE BARRIER POSITIONING KEY SEE FIG Fig. 14 - Removal of Capacity Control Valve LEGEND FOR FIGFig. 13 - Removing Pump End Bearing Head Fig. 15 - Removal of Bypass Piston PlugTable 6 - Compressor Wear Limits Factory Tolerances in Fig. 16 - Valve Plate AssemblyFig. 17 - Suction Valve and Positioning Springs in Place Fig. 19 - Terminal Plate Assembly Cleaning Suction StrainerFig. 18 - Motor End Cover Assembly Compressor Running Gear RemovalCompressor Running Gear Replacement COMPRESSOR MOTOR BURNOUTCompressor cycles on high-pressure TROUBLESHOOTINGCompressor cycles on low-pressure REMEDY PROBLEMCAUSE System noisesCopyright 2002 Carrier Corporation