OIL RETURN LINE CONNECTION
VENT VALVE
Do not run
Wiring diagrams in this publication (Fig.
PUMPOUT CONTROL BOX (WIRING BY CONTRACTOR)
CONDENSER | REFRIGERANT | |
WATER | ||
INLET VALVE | ||
CONNECTIONS | ||
| ||
(FIELD |
| |
INSTALLED) |
|
Fig. 25 Ð Pumpout Unit
INSTALL VENT PIPING TO RELIEF DEVICES Ð The 23XL chiller is factory equipped with relief devices on the cooler and condenser shells. Refer to Fig. 26 and Table 7. Vent relief devices to the outdoors in accordance with ANSI/
To ensure relief valve serviceability and to ful®ll ASHRAE 15, latest edition,
Refrigerant discharged into con®ned spaces can dis- place oxygen and cause asphyxiation.
1.If relief devices are manifolded, the
2.Provide a pipe plug near outlet side of each relief device for leak testing. Provide pipe ®ttings that allow vent pip- ing to be disconnected periodically for inspection of valve mechanism.
3.Piping to relief devices must not apply stress to the device. Adequately support piping. A length of ¯exible tubing or piping near the device is essential on spring- isolated machines.
4.Cover the outdoor vent with a rain cap and place a condensation drain at the low point in the vent piping to prevent water
Make Electrical Connections Ð Field wiring must be installed in accordance with job wiring diagrams and all applicable electrical codes.
NOTE: The relief valve tree is available on all condens- ers. It is also applicable to Frame 4 machines with accessory isolation packages.
Fig. 26 Ð Typical 23XL Relief Valve Tree
Table 7 Ð Relief Device Locations
|
|
|
| LOCATION |
|
|
|
|
| |
|
|
|
|
|
| Oil | Storage | |||
FRAME | Cooler | Condenser |
|
| Tank | |||||
Separator |
| |||||||||
SIZE |
|
|
|
| (Optional) | |||||
|
|
|
|
|
|
| ||||
| Qty | Size | Qty | Size | Qty |
| Size | Qty | Size | |
| (in.) | (in.) |
| (in.) | (in.) | |||||
|
|
|
|
|
|
| ||||
1 or 2 | 1 | 3¤4 | 2 | 3¤4 | 1* |
| 1¤2 | 2 |
| 1 |
FPT | FPT |
| FL |
| FPT | |||||
|
|
|
|
|
|
| ||||
4 | 1 | 1 | 2 | 11¤4 | 2* |
| 3¤4 | 2 |
| 1 |
FPT | FPT |
| FPT |
| FPT | |||||
|
|
|
|
|
|
|
LEGEND
FPT Ð Female Pipe Thread
FL Ð Flare
*Relief valve is only available when an optional (factory installed) or accessory (®eld installed) refrigerant isolation package is used.
Do not attempt to start compressor or apply test voltage of any kind while machine is under dehydration vacuum. Motor insulation breakdown and serious damage may result.
25