FRONT VIEW
1 Ð Compressor Nameplate (Hidden)
2 Ð Power Panel
3 Ð Local Interface Display (LID) Control Center
4 Ð ASME Nameplate, Cooler
5 Ð Cooler
6 Ð Vessel Separation Feet
7 Ð Economizer Float Valve Access Cover (Hidden)
8 Ð Refrigerant Charging Valve
9 Ð Economizer
10 Ð Oil Filter Assembly (Hidden)
11 Ð ASME Nameplate, Economizer
12 Ð Typical Waterbox Drain Port
13 Ð
14 Ð ASME Nameplate, Condenser
15 Ð Cooler Supply/Return End Waterbox Cover
16 Ð Condenser Temperature Sensors
17 Ð Cooler Relief Valve
REAR VIEW
18 Ð Unit Mounted Starter (Option)
19 Ð ASME Nameplate, Oil Separator
20 Ð Oil Separator Relief Valves
21 Ð Oil Separator
22 Ð Oil Charging Valve
23 Ð Condenser Isolation Valve (Option or Accessory)
24 Ð Service Valve
25 Ð Cooler Refrigerant Isolation Valve
26 Ð Condenser Relief Valves and Oil Filter
27 Ð Float Chamber
28 Ð Poppet Valve Assembly
29 Ð Motor Cooling Isolation Valve
30 Ð Condenser
31 Ð Condenser Supply/Return End Waterbox Cover
32 Ð Cooler Temperature Sensors
33 Ð Machine Identi®cation Nameplate
Fig. 3 Ð Typical 23XL Installation (Frame 4 Machine)
Rigging the Machine Ð The 23XL can be rigged as an entire assembly. It also has ¯anged connections that allow the compressor, cooler, condenser, and oil separator sections to be separated to ful®ll speci®c installation requirements.
RIG MACHINE ASSEMBLY Ð See rigging instructions in plastic envelope attached to machine. Also refer to rig- ging guide (Fig. 4 and 5), physical data in Fig. 6 and 7, and Tables
Lifting machine from points other than those speci®ed may result in serious damage and personal injury. Rig- ging equipment and procedure must be adequate for machine weight. See Tables
NOTE: These weights are broken down into component sections for use when installing the unit in sections. For complete machine weight, add all section components together. Total machine weight (Table 6) is also sten- ciled on the cooler and condenser sections.
4
