Configuration
Web-Based Management
The
To access the management console
NOTE: The following assumes that you have connected the PC to the LAN port of the Adit 3104.
1.Launch a web browser on your PC in the LAN to which the Adit 3104’s LAN port is connected. Note: If connection to the Adit 3104 is to be through an Ethernet or T1 WAN, the remote admin WAN access must be enabled with the following command sequence:
Command | Description |
Username: admin | Log into the system (username and password). |
Password: ******** |
|
Adit 3104> enable | Enter the Privileged mode. |
Password: ******** | Enter password for the Privileged mode. |
#configure terminal | Enter the Configuration mode. |
(config)# | Enable remote web admin. |
|
2.Type the Adit 3104’s IP address or name in the address bar. Example: http://192.168.1.1.
Default IP address is http://192.168.1.1
Note: To display the current IP address of the systems, use the following CLI command: #show interface ethernet 1 (LAN)
#show interface ethernet 2 (Eth WAN)
3.Login to the unit.
Enter User Name and Password. Note: These setting should be changed from the default settings after the initial login.
Default user name is admin
Default password is admin 123
NOTE: After a few minutes of inactivity, the session will automatically timeout and the operator will be required to log in to continue the session.
WARNING! IF YOUR USER NAME AND PASSWORD ARE SET TO THE DEFAULT SETTING, IT IS RECOMMENDED THAT YOU MODIFY THEM FOR SECURITY PURPOSES.
Adit 3104 - Release 1.6 |
