Casio AT-3, AT-5 manual 135

				Using a Memory Card
4. Use the R-17 (t, y) buttons to move the 0to		3. Depending on the type of data you want to save
	“CardFormat”.	to the memory card, perform one of the steps
		shown below.
		• All setup registration banks are saved as a batch. Other
		data is saved in area (data item) units.
		To save this		Do this:
		type of data:
		One user rhythm	1.	Press the L-9 ([F] USER RHYTHMS)
				button.
			2.	Use the dial or R-14(–, +) buttons to
				specify the user rhythm number.
5. Press the R-16 (ENTER) button.
		One user tone	1.	Press the R-12 ([L] USER TONES)
	• This will cause the confirmation message “Sure?” to			button.
			2.	Use the dial or R-14(–, +) buttons to
	appear.
				specify the user tone number.
6. Press the R-14 (YES) button to format the
		One user DSP	1.	Perform steps 1 through 4 under “To use
	memory card or the R-14 (NO) button to cancel.		2.	a DSP” (page E-34).
	• The message “Please Wait” will remain on the display			Use the dial or R-14(–, +) buttons to
				specify the user DSP number (101
	while the format operation is being performed. Do not
				through 200).
	perform any Digital Keyboard operation while this
		One user preset	1.	While holding down the L-7 ([D] ARABIC/
	message is on the display. “Complete” appears on the
	display after formatting is complete.			ORIENTAL) button, press the L-8 ([E]
				PIANO RHYTHMS) button to display the
	• Formatting may take as long as a few minutes to
				music preset screen.
	complete.
			2.	Press the L-9 ([F] USER RHYTHMS)
				button.
	Saving Digital Keyboard Data to a
			3.	Use the dial or R-14(–, +) buttons to
	Memory Card			specify the user preset number.
		One song	1.	Press the C-5 (SONG SEQUENCER)
	To save Digital Keyboard data to a memory	sequencer song		button to enter the song sequencer mode.
			2.	Use the dial or R-14(–, +) buttons to
	card			specify the song number.
		All registration	Press the C-10 (BANK) button to display the
1. Insert the memory card into the card slot.
		banks	registration bank selection screen.
2. If the Digital Keyboard is in the card mode,		All scale memory	While holding down the R-13 (FUNCTION)
		data	button, press the C-8 (SCALE) button to
	press the C-9 (CARD) button to exit the card
			display the scale screen.
	mode.

4. While holding down the R-13 (FUNCTION) button, press the C-9 (LOAD/SAVE) button.

• This causes an “Xxxx Load”*1 screen like the one shown below to appear. The sample screen below shows the screen that appears from the rhythm screen.

E-133