Casio AT-3, AT-5 manual 74

Using the Song Sequencer

6. Press the L-17 (START/STOP) button.				To specify the punch-in recording range
	•	This starts punch-in playback.
				before starting (Auto Punch-in)
	•	The following operations are supported during punch-in
				1. Play the song and determine what part of what
		playback. They help you move to the re-recording start
		point quickly and easily.		track you want to re-record.
		To do this:	Do this:	•	For details about play back, see “Playing a Recorded
	Fast Forward		Hold down the L-15 (dFF) button.		Song” (page E-74).
				•	You can specify a specific measure, beat, and tick* for
	Fast Backward		Hold down the L-14 (sREW)
					the start point and the end point of the range to be
			button.
					re-recorded. Normally, it is probably best to specify the
	Pause		Press the L-16 (PAUSE) button.		start of a measure or beat as the start point and end
					point. If you want to specify specific ticks, you can
	Restart paused		Press the L-16 (PAUSE) button.
					display the track to be re-recorded on the event editor
	playback.
					screen and determine the desired location there. For
7. When playback reaches the point from which					details about event editing, see “Editing Events” (page
					E-82).
	you want to start re-recording, start playing
					* For details about ticks, see “Reading Event Data”
	something on the keyboard.
					(page E-83).
	•	Punch-in recording starts the moment you start to play		2. Press the C-6 (RECORD) button to enter record
		something on the keyboard.
	•	Any one of the following also will start punch-in		standby.
		recording: a pedal or pitch bender operation; changing		•	This causes the button to start flashing.
		the tone setting; changing the rhythm, or tempo		3. Use the R-17 (u, i) buttons to select the track
		setting*.
		* System track only		you want to partially re-record.
	•	To start punch-in recording without making any change		4. Hold down the C-6 (RECORD) button until the
		in the notes played or the settings used, press the C-6
	•	(RECORD) button.		punch-in/punch-out screen appears. You can
		Starting recording will cause the C-6 (RECORD) button		release the button at that time.
		to light.
				5. Use the dial or the R-14 (–, +) buttons to select
				“Auto” for the “Mode” setting.
• If you want to delete all of the data in the track following the
				•	This displays a range specification screen like the one
	section you just re-recorded with punch-in recording, press
					shown below.
	the C-6 (RECORD) button in place of the L-17 (START/
	STOP) button in step 8.

•If you want to cancel punch-in recording and retain the original track data, hold down the C-6 (RECORD) button until it becomes unlit.

8.To stop recording, press the L-17 (START/ STOP) button.

•This will end punch-in recording and cause the C-6 (RECORD) button to become unlit.

•Any previously recorded data in the track that comes after the point you stopped punch-in recording will remain in the track.

E-72