Using the Tone Editor

4.Use the dial or R-14 (–, +) buttons to change the

 

 

setting value.

• The message “Please Wait” will remain on the display

 

 

• Pressing the R-14(–, +) buttons at the same time

 

 

 

 

while a data save operation is in progress. Do not

 

 

returns a parameter to its initial default setting.

 

 

 

 

 

 

perform any other operation while it is displayed.

5. Repeat steps 3 and 4 as required to configure

 

 

 

 

Turning off the Digital Keyboard or removing the

 

 

other parameters.

 

 

memory card can cause Digital Keyboard data to be

 

 

 

 

deleted or become corrupted. It also can cause the

 

 

 

 

 

 

 

 

 

6. To save a rhythm after you edit it, hold down

 

 

Digital Keyboard to fail to turn on when the L-1

 

 

(POWER) button is pressed. If this happens, refer to

 

 

the R-13 (FUNCTION) button as you press the

 

 

 

 

 

 

“Troubleshooting” (page E-145).

 

 

C-17 (MENU) button.

 

 

 

 

 

 

 

 

 

 

• This displays the tone editor menu.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7.

Press the R-16 (ENTER) button.

•

Pressing the R-15 (EXIT) button in place of step 6 displays

 

 

the confirmation screen shown below. Pressing the R-14

 

 

• This displays a screen for specifying the destination

 

 

 

 

 

 

(YES) button at this time will display the tone save screen in

 

 

user tone number and tone name.

 

 

step 7.

 

 

 

 

 

 

 

 

 

 

 

Destination user tone number

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Tone name

To cancel the editor operation without saving the edited results, press the R-14 (NO) button.

8.Use the dial or R-14 (–, +) buttons to select the destination user tone number you want.

9.Use the R-17 (u, i) buttons to move the cursor to the name character position you want to change, and then use the dial or R-14 (–, +) buttons to select the character you want.

•See “Supported Input Characters” (page E-155) for information about the characters you can input for the name.

•To input a space, press both of the R-14(–, +) buttons at the same time.

10.After everything is the way you want, press the R-16 (ENTER) button.

•A message (Replace?) will appear on the display to confirm whether you want to replace the existing data with the new data. Press the R-14 (YES) button to replace the existing data with the new data.

E-46