Using the Bar Code Reader
Adjusting the Laser Beam Width
The width of the laser beam emitted from the Handheld Terminal can be adjusted to match the width of the bar code that is being read.
When you switch the laser beam width, you must set the beam’s reference point beforehand.
1 Turn the Handheld Terminal ON with the 
and 
keys held down to start up the system menu.
2 Press the following keys in order to start up laser beam adjustment:
Mode Set
Bar Code
Laser Beam Adjustment
Startup Screen
OBR CALIBRATION
PLEASE PUSH TRG KEY
TRG :START
CLR :EXIT
3 Press the trigger key to emit the laser beam, and align the laser beam with the beam width adjustment bar code.
*Align the laser beam with the fine bars on both sides of the adjustment bar code.
(Example)
After first making sure that the laser beam is emitted at the correct position, hold down the trigger key for at least one second.
Laser beam adjustment is completed when you release the trigger key.
Adjustment Screen
Calibration
Completed
Screen
OBR CALIBRATION
EXECUTING.....
TRG :STOP
OBR CALIBRATION
FINISHED
✱COMPLETE
TRG :RETRY
CLR :EXIT
