Using the Satellite Cradle
Charging the Battery Pack
(charging the lithium-ion battery pack separately)
1 Set the power switch of the Satellite Cradle to the ON position. The power indicator of the Satellite Cradle lights red.
2 Load the battery pack in the spare battery compartment on the Satellite Cradle, making sure that the terminals on the side and rear of the battery pack come into close contact with the battery pack charge terminals.
The battery pack charge indicator (“CHG 2”) lights red, and charging is started.
Spare Battery Pack Charge Indicator
(“CHG 2”) |
|
Lit Red: | Charging (charging |
| standing by when the |
| battery in the Handheld |
| Terminal is charging) |
Lit Green: | Charging complete |
Battery pack |
Power |
switch (ON) |
System operation indicator |
Communication indicator |
Spare Battery Pack Charge |
Indicator (“CHG 2”) |
Battery Pack Charge Indicator |
(“CHG 1”) |
Power indicator |
•When the battery pack charging indicator lights red and then goes out after several seconds, this indicates a battery pack problem.
•Charging of the battery in the Handheld Terminal is given precedence. Separate charging of the battery pack cannot be performed simultaneously while charging of the battery in the Handheld Terminal.
[Caution]
■Ambient Temperature Ranges for the Battery Pack
•Temperature ranges for battery pack use in the Handheld Terminal, charging, and storage are specified below. Temperatures outside these ranges create the danger of deterioration of battery pack performance and shortening of its service life, as well as fluid leakage and heat generation.
Operating Temperature:
Charging Temperature: 0°C to 40°C
Storage Temperature:
Important! • If the battery pack charge indicator does not light during charging, remove the battery pack and then
•Use only the specified battery pack.
•Battery packs naturally discharge even when they are not loaded in the Handheld Terminal. Use a battery pack as soon as possible after charging it.
•For best charging results, keep the Satellite Cradle, Handheld Terminal and battery pack contacts clean by periodically wiping them off with a cotton swab or dry cloth.