Saving Digital Piano Setups (Registration Memory)
Registration Data Storage Notes
•Registration data is stored even when the digital piano is turned off.
•Storing new data in an area replaces any data that is currently in the same area.
•The digital piano is shipped from the factory with registration data stored in each area. You can restore this original data by performing the procedure under “Returning the Digital Piano to Its Factory Default Settings” on page
•You can save registration data to an SD memory card, if you want. See “Using an SD Memory Card” on page
IMPORTANT!
•CASIO COMPUTER CO., LTD. takes no responsibility for any damages, lost profits, or claims by third parties arising from the loss of deleted recorded data due to malfunction, repair, or for any other reason.
To store a setup in registration memory
1. On the digital piano, configure the tone, rhythm, and other settings you want to save as your setup.
•See “Registration Data Contents” (page
NOTE
•If you use the FUNCTION button to configure a setting, make sure that the FUNCTION button lamp is unlit before you advance to step 2. If the lamp is lit, press the FUNCTION button so it goes out.
2. While holding down the STORE button, use the T/NO and S/YES buttons to display the number of the bank where you want to store the registration data.
•This will display the bank number and then display the screen for specifying the area number.
Example: Bank 1 selected
3. While holding down the STORE button, press one of the area buttons (1 through 12), to select the area where you want to save the registration data.
•The lamp of the applicable area button will light after registration is complete. Also, the message “CPL” (complete) will appear on the display.
Example: After data has been saved to area
4. Release the STORE button.
NOTE
•Registration data cannot be stored when any one of the following conditions exists. Eliminate the problem condition and perform the procedure from step 2.
•The digital piano is in the Duet Mode.
•Song, rhythm, or metronome is playing.
•Two RECORDER button lamps are lit or flashing.