Reprogramming a Single HomeLink

®

Button

To program a device to HomeLink
®
using a HomeLink
®
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
®
button. Do
not release the button.
2. The indicator light will begin to flash after
20seconds. While still holding the HomeLink
®
button, proceed with Step 2 under “Programming
HomeLink
®
” shown earlier in this section.

Resetting Defaults

To reset HomeLink
®
to default settings do the following:
1. Hold down the two outside buttons for about
20seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
®
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
®
at
1-800-355-3515, or on the internet at
www.homelink.com.
Storage Areas

Glove Box

To open the glove box, lift up on the lever. The glove
box has a light inside.

Front Storage Area

To use the storage area, fold down the armrest located
in the center front seat. Press the latch on the front
edge and pull up to access the storage area.

Center Console Storage Area

Your vehicle may be equipped with a center console. It
has cupholders and a storage area. To open the
console’s storage area, pull up on the latch located in
the front of the console lid.

Rear Storage Area

If your vehicle has the split folding rear seat, there will
be two cupholders in the rear seat armrest. To
access them, pull down on the cloth strap located
toward the top of your center back seat cushion.
2-36