Jack PC Hardware User Manual - Training Department
Version 0506
3.4Existing LAN Installation
Tools you will need for Existing Jack Installation:
∙Power-over-Ethernet Tester (where PoE is available (see power options 1 and 2 in the introduction chapter) – it is recommended to verify that the LAN jack receives power with this tester) - this is an optional accessory that you need to purchase separately (Chip PC part number: CPN02239 – see accessories list).
∙Screwdriver / Powered-screwdriver
∙RJ-45 Termination Connector Block (this is an optional accessory that you need to purchase separately)
∙Half-round File to trim wall cutout
∙Cloth to clean Housing contacts
∙Extraction Tool to remove device after it was installed
1Use Power-over-Ethernet tester (Chip PC part number: CPN02239) to check existence of PoE in the Jack designated for installation.
Note: In case there is no PoE available, Jack PC can be powered by External power supply (see step 13).
2Remove the existing LAN Jack from the wall.
Separate the LAN Jack module from the front panel.
3Pull out the LAN cable, holding the RJ-45 Termination Connector Block,
4Connect the LAN jack and RJ-45 connector on the RJ-45 Termination Connector Block (this is an optional accessory that you need to purchase separately, in case you did not order this part – go to New installation paragraph (3.5), and continue the instructions in the table from step 3).
12
