Jack PC Hardware User Manual - Training Department
Version 0506
3.7Turning the Jack-PC ON
After you have connected all peripherals and cables, follow these steps to turn your Jack PC ON:
∙In case you have
∙In case you are using an External power supply, it is recommended to turn ON all peripherals connected to the system such as monitor & printer and then connect the power supply to the
The green Power/Fail LED will illuminate during the system boot.
Once the system is up, the Power/Fail LED will be lit in steady green. The system loading screen will appear, followed by several status messages. If IP address successfully received from DHCP, the desktop screen will be shown.
The Jack PC device does not have a power switch as it is fully manageable through software. During inactivity periods it switches automatically to various Low Power Modes. Power consumption reduced bellow 1W but still the device is monitoring the LAN for Xcalibur Global Management Software commands or upgrades. When keyboard or mouse activities are detected, the device will switch to full power in less than 0.1 seconds.
3.8Unplugging the System When Using External Power
If you are not going to use the system for a long period of time you should do the following:
∙Log off from any open connections/sessions.
∙Unplug the system from the mains socket.
3.9Reseting the Jack-PC
Pressing the RESET Button will cause the Jack PC to reboot, execute
Note: The RESET Button performs reset only to the
22