Chip PC CDC01927 manual

Jack PC Hardware User Manual - Training Department

Version 0506

6Close the IDC Termination Connector Block and insert it into the Housing bottom part until you hear a clicking sound indicating it has locked properly into place.

In case the Connector Block in not locked in to position, you can slightly bend the metal tab to create more pressure on the Connector Block.

It is recommended to verify that the wires are connected properly to the Flex-Jack terminal block before securing it in to the wall! See chapter 6 for more information.

6Place the Flex-Jack Housing inside the Jack hole. Trim wall cutout if necessary.

7Make sure that the Flex-Jack Housing is fully inserted, level- headed and that the Housing contacts are located at the bottom part as shown in picture.

Secure with 4 screws.

8Gently clean the Flex-Jack Housing contacts from dust, debris and other objects.

18