Cisco Systems 12 SP+ manual Directory Number Configuration Settings, 42-32

Chapter 42 Cisco IP Phone Configuration

Configuring Directory Numbers

Directory Number Configuration Settings

Table 42-3describes the fields available on the Directory Number Configuration Settings pane.

Table 42-3 Directory Number Configuration Settings

		Field	Description
		Directory Number	Enter a dialable phone number. Values can include
			numeric characters and route pattern wildcards and
			special characters except for (.) and (@). The directory
			number you enter can appear in more than one partition.
			If the words Shared Line appear in red next to the
			directory number, the directory number appears on more
			than one device in the same partition. Refer to the
			“Directory Numbers” section in the Cisco CallManager
			System Guide for more information.
		Partition	Choose the partition to which the directory number
			belongs. Make sure the directory number you enter in the
			Directory Number field is unique within the partition you
			choose.
		Voice Message Box	Enter the voice mailbox you want to associate with this
			line. When a call is forwarded to voice mail, the
			Cisco CallManager sends the number you enter here to
			your voice-mail application. The voice-mail system then
			leaves voice-mail messages in the configured mailbox.
			By default, the Cisco CallManager Administration enters
			the directory number in this field.
			During auto-registration, Cisco CallManager applies the
			default mask value you entered in the the Voice Message
			Box Mask field on the Cisco CallManager Configuration
			pane to this field.
			For example, if you enter 97281XXXXX in the Voice
			Message Box Mask field and you enter 30000 in the
			Voice Message Box field, Cisco CallManager identifies
			the voice message box for this directory number as
			9728130000.
	Cisco CallManager Administration Guide
42-32			78-13310-01