Chapter1 Introducing the Content Engine
Introduction
1-2
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Figure1-1 CE-511 and CE-566—Front View
This guide describes the Content Engine models listed below.
The CE-511 and CE-566 are configured for AC-input power and have a single
AC-input power supply.
The Content Engine comes with an integrated dual-port Ethernet controller. This
controller provides an interface for connecting to 10-Mbps, 100-Mbps, or
1000-Mbps networks.
Content Engines have two 10BASE-T/100BASE-TX/1000BASE-TX Ethernet
ports with RJ-45 receptacles. Both Ethernet ports support autodetect speed mode
and full-duplex operation, which enable simultaneous transmission and reception
of data on the Ethernet LAN.
In addition, the CE-566 is configured with one Ultra320 low-voltage differential
(LVD) small computer system interface (SCSI) connector for attaching the Cisco
Storage Array. The SCSI adapter is installed in Peripheral Component
Interconnect-Extended (PCI-X) slot 2 on the back panel. (See Figure1-2.)
115770
Model Product Number
Content Engine 511 CE-511-K9
Content Engine 566 CE-566A-144GB-K9