Cisco Systems 511, 566 Connecting Power and Booting the System

3-13

Cisco Content Engine 511 and 566 Hardware Installation Guide

OL-5756-01

Chapter3 Installing the Content Engine

Connecting Power and Booting the System

Figure3-9 CE-511 and CE-566 Back Panel Ports and Receptacles

Note Cisco ACNS software does not support the use of a keyboard or mouse (PS/2 or

USB) with the Content Engine. However, keyboard and mouse are supported by

the BIOS for power-on self-test (POST), and the configuration/setup utility.

Connecting Power and Booting the System

Follow these steps to connect power to the Content Engine:

Step1 Review the information in the “Safety Warnings” section on page 2-1.

Step2 Plug the AC power cord into the power cord receptacle at the rear of the

Content Engine. (See Figure3-9.)

Step3 Connect the other end of the power cord to a power source at your installation site.

1AC power receptacle 2Mouse connector

3Keyboard connector 4Ethernet 1 receptacle

5Ethernet 2 receptacle 6USB ports (not supported)

7Video connector 8Serial connector

115773

1 2 3 4

8 7 5

6

Contents

Main Page Page Page CONTENTS Page Page Page Preface Document Objectives Audience Document Organization Document Conventions Page xiii xiv xv xvi xvii xviii Page Page Obtaining Documentation Cisco.com Ordering Documentation Documentation Feedback Obtaining Technical Assistance Cisco Technical Support Website Submitting a Service Request Definitions of Service Request Severity Obtaining Additional Publications and Information Page Page Introducing the Content Engine Introduction Page Page Content Engine 511 Content Engine 566 Functional Description Content Delivery Network Component Content Caching Device Hardware Features Front Panel Control Buttons LED Indicators 1 2 3 4 5 Page Page Input/Output Ports and Connectors 1 2 3 4 8 7 5 6 Page Ethernet Port Ethernet Port Connector Serial Port Serial Port Connector SCSI Port SCSI Connector Fibre Channel Port Fibre Channel Connector Video Port Video Connectors Page Specifications Page Page Regulatory Compliance Page 1-22 Class A Warning Statements VCCI Class A Warning for Japan Class A Notice for Taiwan and Other Traditional Chinese Markets 1-23 Class A Warning for Hungary Page Preparing to Install the Content Engine Safety Warnings 2-2 2-3 Safety Guidelines General Precautions Page Protecting Against Electrostatic Discharge Rack Installation Safety Guidelines Page Page Installing the Content Engine Tools and Parts Required Installing a CE-511 or CE-566 Unit Installing the Chassis in a 2-Post Rack Installing the Chassis in a 4-Post Rack Page 1 2 Page Page Page Page Installing the Chassis on a Tabletop Connecting Cables Connecting Power and Booting the System 1 2 3 4 8 7 5 6 Checking the LEDs Removing or Replacing a Content Engine Page Page Installing Hardware Options Removing the Cover and Bezel Page Installing Adapters Page Installing an MPEG Decoder Adapter Page Page Preparing and Installing a Fibre Channel Adapter Preparing to Install the Adapter Fiber-Optic Cabling Guidelines for the Fibre Channel Adapter Tools and Parts Required Installing the Fibre Channel Adapter Troubleshooting the Fibre Channel Adapter Installation Hardware Problems System Configuration Problems Fibre Channel Problems Working with Hard Disk Drives Installing a Hard Disk Drive in the CE-511 Page Installing a Hard Disk Drive in the CE-566 Page Assigning SCSI IDs Completing the Installation Installing the Content Engine Cover and Bezel Page Troubleshooting the System Hardware Checking the Basics Checking Connections and Switches Page Page Maintaining the Content Engine Maintaining Your Site Environment Temperature Humidity Altitude Dust and Particles Corrosion Electrostatic Discharge Electromagnetic and Radio Frequency Interference Magnetism Power Source Interruptions Using Power Protection Devices Surge Protectors Line Conditioners Uninterruptible Power Supplies Page INDEX A B C D E F H I L M N P R S T U V W