1-13
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Chapter1 Introducing the Content Engine
Hardware Features
Ethernet Port
The Content Engine comes with one integrated dual-port Ethernet controller. This
controller provides an interface for connecting to 10-Mbps, 100-Mbps, or
1000-Mbps networks and provides full-duplex (FDX) capability, which enables
simultaneous transmission and reception of data on the Ethernet LAN.
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the back of the device.
Note The 100BASE-TX/1000BASE-TX Ethernet standard requires that the cabling in
the network be Category 5 or higher.

Ethernet Port Connector

Figure 1-10 shows the pin number assignments for the Ethernet RJ-45 port.
Figure1-10 Ethernet Port Connector
Serial Port
The Content Engine has one standard serial port connector located on the back of
the device.

Serial Port Connector

Figure 1-11 shows the pin number assignments for the 9-pin, male D-shell serial
port connector on the back of the device. These pin number assignments conform
to the industry standard.
1
8
Link LED
(green)
Activity LED
(green)
83195