Chapter3 Installing the Content Engine
Checking the LEDs
3-14
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Step4 Power up all externally connected devices.
Step5 Press the power control button on the front of the Content Engine.
The system should begin booting. Once the operating system boots, you are ready
to initialize the basic software configuration. (Refer to the software configuration
guide or user guide that shipped with your system.)
Note While the Content Engine is powering up, the green power on LED on the
front of the Content Engine is on.
Note You can install a circular disk over the power control button to prevent accidental
manual power down. This disk, known as the power control button shield, comes
with the Content Engine.
Checking the LEDs
When the Content Engine is up and running, observe the front panel LEDs.
(See the “LED Indicators” section on page1-8 to verify that your system is
operating properly.)
Removing or Replacing a Content Engine
Warning
Before working on a system that has an on/off switch, turn OFF the power and
unplug the power cord.
Statement 1
Warning
Ultimate disposal of this product should be handled according to all national
laws and regulations.
Statement 1040