Chapter3 Installing the Content Engine
Connecting Cables
3-12
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Connecting Cables
Follow these steps to connect network, console, and SCSI cables to the
Content Engine.
Note The SCSI cable is part of the Cisco Storage Array accessory kit. If you did not
order the Cisco Storage Array, you did not receive a SCSI cable.
Step1 For network connections, insert a Category 5 UTP cable into the Ethernet 1 or
Ethernet 2 receptacle on the Content Engine back panel. (See Figure 3-9.)
Step2 Connect the other end of the network cable to a hub or switch in your
network.
Step3 For console connections, plug the serial cable into the serial port on the
Content Engine back panel.
Step4 Connect the other end of the console cable to a console or a communications
server.
Step5 If you are using a Cisco Storage Array as an external storage device, attach the
SCSI cable to the SCSI LVD port.
Caution Make sure to tighten the jackscrews on the SCSI cable.
Note SCSI port is available only on CE-566 model.
Step6 Connect the other end of the SCSI cable to the appropriate port on the
Storage Array.
For further information about the Cisco Storage Array, refer to the
Cisco StorageArray Installation and Configuration Guide publications.