Cisco Systems 535 user service VPN Accelerator Circuit Board, Gigabit Ethernet Circuit Board

Chapter 7 PIX 535

Installing a Circuit Board in the PIX 535

Step 5 Remove any previously installed Flash memory circuit boards from the unit.

Step 6 The jumper on the PIX security appliance 16 MB Flash circuit board must not be removed or repositioned. The PIX security appliance system will not work if this jumper is moved.

Step 7 Install the 16 MB Flash circuit board into an available ISA slot in the PIX security appliance chassis.

VPN Accelerator Circuit Board

The VPN Accelerator (PIX-VPN-ACCEL) is an encryption and accelerator circuit board. The VPN Accelerator uses a PCI interface and therefore can only be installed in PIX security appliance platforms with PCI slots. The VPN Accelerator begins to function immediately after installation without the need of special installation configurations.

Note The new VPN Accelerator cannot be used with the former PIX security appliance IPSec accelerator in the same chassis. The PIX security appliance IPSec accelerator was also known as the Private Link card.

An illustration of the VPN Accelerator is shown in Figure 7-14.

Figure 7-14 PIX Security Appliance VPN Accelerator Circuit Board

61921

Gigabit Ethernet Circuit Board

PIX security appliance supports 1000 Mbps (Gigabit) Ethernet. The Gigabit Ethernet circuit board has only one hardware speed and supports the following duplex options:

•1000SXfull—Forces full-duplex operation

•1000BaseSX—Forces half-duplex operation

•1000auto—Auto negotiates full or half duplex

Cisco PIX Security Appliance Hardware Installation Guide

7-20 78-15170-03