Example of Frame Relay Configuration Output

Step 15 Specify a DLCI number that is used to connect to the Internet service provider. For example:

router(config)# frame-relay interface dlci 16 ieft

Step 16 End configuration mode.

router(config)# end router#

Step 17 In user mode, set global NAT commands. In the following example, all inside network addresses assigned to interface BRI0 are configured for translation, and the access list that contains the inside network addresses is defined.

router# ip nat inside source list 1 interface bri0 overload

router# access-list1 permit 192.168.1.0 0.0.0.255

Step 18 Save your configuration.

router# copy running-config startup-config

Example of Frame Relay Configuration Output

Current configuration:

!

!

version 12.0

service timestamps debug uptime service timestamps log uptime

!

hostname c802idsl

username isp password 0 cisco

!

!

ip subnet-zero

!

isdn switch-type basic-5ess isdn leased-line BRI0 144 isdn leased-line BRI0.1 144

!

!

interface Ethernet0

ip address 192.168.2.1 255.255.255.0 ip nat inside

!

interface BRI0 no ip address

encapsulation frame-relay IETF frame-relay lmi-type ansi

!

interface BRI0.1 point-to-point

ip address 209.188.2.2 255.255.255.0 frame-relay interface-dlci 16 IETF ip nat outside

!

ip nat inside source list 1 interface bri0:1 overload access-list 1 permit 192.168.2.0 0.0.0.255

Installing and Configuring Cisco 802 IDSL and Cisco 804 IDSL Routers

 

78-10368-03

15

 

 

 

Page 15
Image 15
Cisco Systems 804, 802 manual Example of Frame Relay Configuration Output, Interface BRI0.1 point-to-point