Cisco Systems Catalyst 2955 manual Inch 6.35 mm Inch 19.05 mm

Chapter 3 Installation

Connecting the Switch to the Power Converter

Follow these steps to prepare an AC power cord to connect to the power converter.

Warning When installing the unit, always make the ground connection first and disconnect it last. Statement 42

Step 1 Cut off the female connector on the cord.

Step 2 Using a wire-stripping tool, strip the outer insulation layer 1 inch (2.54 cm).

Step 3 Strip the inner wire insulation to 0.25 inch (6.3 mm) ± 0.02 inch (0.5 mm), as shown in Figure 3-15.

Figure 3-15 Preparing the AC Power Cord

1

2

104352

1

0.25 inch (6.35 mm)

2

0.75 inch (19.05 mm)

	Catalyst 2955 Hardware Installation Guide
3-36	78-14944-03