Appendix B Connectors and Cables
Cable and Adapter Specifications
Note You can get replacement power and relay connectors (PWR-2955-CONNECT=) by calling Cisco Technical Support. See the “Obtaining Technical Assistance” section on page xxx.
Figure B-5 Power and Relay Connector
| | ALARMS | | |
24V A | RTN A | MAJ MIN | RTN B | 24V B |
76661
Console Port
The console port uses an 8-pin RJ-45 connector. You can connect a switch to a PC through the console port and the supplied RJ-45-to-DB-9 adapter cable. If you want to connect a switch to a terminal, you need to provide an RJ-45-to-DB-25 female DTE adapter. You can order a kit (part number ACS-DSBUASYN=) with that adapter from Cisco. For console-port and adapter-pinout information, see Table B-3and Table B-4.
Cable and Adapter Specifications
These sections describe the cables and adapters used with Catalyst 2955 switches.
•Two Twisted-Pair Cable Pinouts, page B-6
•Four Twisted-Pair Cable Pinouts for 10/100 Ports, page B-6
•Four Twisted-Pair Cable Pinouts for 1000BASE-T Ports, page B-8
Catalyst 2955 Hardware Installation Guide