![](/images/new-backgrounds/1170300/170300243x1.webp)
Chapter 3 Installation
Installing the Switch in a Rack
To install the switch in a rack, follow these steps:
Step 1 Use the four Phillips machine screws to securely attach the brackets to the rack, as shown in Figure
Figure 3-30 Installing the DIN Rail Adapter
87055
Step 2 Position the rear panel of the switch directly in front of the DIN rail, making sure that the top of the DIN rail clip hooks over the top of the DIN rail, as shown in Figure
Step 3 Rotate the switch down toward the DIN rail until the release tab on the rear panel clicks.
Step 4 Lift lightly on the bottom of the switch to ensure that it is firmly locked in place. See Figure
| Catalyst 2955 Hardware Installation Guide |