Cisco Systems CIVS-IPC-2621V manual Attaching the Base Plate to a Junction Box

Chapter 2 Getting Started

Installing the Cisco Video Surveillance 2621 IP Dome

Figure 2-3 Attaching the Base Plate to a Junction Box

1

2

Junction box

Base plate

Step 5 Put the an category 5 or higher Ethernet cable through the camera housing and connect it to the LAN port on the IP dome (see Figure 1-1 on page 1-3).

Caution Do not lift the IP dome by the Ethernet cable.

Step 6 If the IP dome will not receive PoE, put the power cable through the camera housing and connect it to the power input on the IP dome (see Figure 1-1 on page 1-3).

To connect a power cable, use a flat-head screwdriver to depress the brown tabs on the power input and connect bare positive, negative, and ground wires as shown on the label that is affixed to the IP dome.

Step 7 (Optional) Connect an external speaker, microphone, or both to the Y cable, then connect the Y cable to the audio port on the IP dome.(see Figure 1-1 on page 1-3). The Y cable that is included in the optional audio/video cables accessory kit can be purchased from Cisco (Cisco part number CIVS-IPCA-1017=).

Each device connects to the audio cable through a standard 3.5 mm mini phone jack. A speaker connects to the green jack, which is labeled “Audio Out.” A microphone connects to the pink jack, which is labeled “Audio In.”

Cisco Video Surveillance System 2621 IP Dome User Guide

2-6 OL-24129-02