Cisco Systems CIVS-IPC-2621V manual Adjusting the Camera Lens on the 2621 IP Dome

Chapter 2 Getting Started

Adjusting the Video Image

camera at an object that is at least 15 feet (4.5 meters) away and gently sliding the lens toward or away from the camera. Take care not to pull the lens completely away from the camera.Obtain a sharp picture in both wide-angle and telephoto positions. When the focus is set as desired, use the Allen wrench to tighten the back focus hex screw.

Caution Do not manually adjust the focus or zoom for the IP camera. Attempting to manually do so may damage the IP camera lens. Instead, use the Focus/Zoom window in the configuration software to remotely set the focus and zoom for the IP camera.

Figure 2-16 Adjusting the Camera Lens on the 2621 IP Dome

1

2

1Rotation wheel

2Panning lock screw

3Tilt lock screws (2)

4Back focus hex screws (3)

3

4

Step 4 Remove the analog monitor cable from the analog video output port.

Step 5 Replace the privacy shield by squeezing it to fit inside the four tabs on the camera unit.

Make sure to adjust the privacy shield inside the dome and trim ring assembly so that it does not block the lens from capturing video.

Step 6 Align the tab on the dome assembly with the opening in the base plate, press the dome assembly into place, and securing the three TORX screws

	Cisco Video Surveillance System 2621 IP Dome User Guide
OL-24129-02		2-27