Cisco Systems CIVS-IPC-2621V manual See -1 on, Attaching the Camera Unit to the Base Plate

Chapter 2 Getting Started

Installing the Cisco Video Surveillance 2621 IP Dome

Step 12 (Optional) Use the GPIO ports to connect external devices that trigger alarms (connect through alarm input ports) or respond to alarms (connect through alarm output ports).

See Figure 1-1 on page 1-3.

Step 13 Attach the camera unit to the base plate by aligning the three tabs on the camera unit with the slots on the base plate, pressing the camera unit into the base plate until the tabs snap into place, and securing the camera unit with the two camera unit screws (see Figure 2-9).

Figure 2-9 Attaching the Camera Unit to the Base Plate

1

2

Base plate

Camera unit

Step 14 See Figure 2-16 on page 2-27and take these actions to adjust the camera lens to obtain the desired image:

•Temporarily attach an analog monitor to the IP dome so that you can see video while adjusting the camera. If the cable from the monitor terminates with a 3.5 mm jack, plug it into the analog video output port on the IP dome. If the cable terminates with a BNC connector, connect it to the mini cable with BNC adapter, then plug the cable into the analog video output port. The mini cable with BNC adapter is included in the audio/video cables accessory kit, which you can purchase from Cisco (Cisco part number CIVS-IPCA-1017=).

	Cisco Video Surveillance System 2621 IP Dome User Guide
OL-24129-02		2-13