Cisco Systems OL-3598-02 manual Enabling Traps on the Device

Chapter 2 Installing the EM

Configuring the System

Step 5 If the router does not currently accept Telnet sessions, enter commands as follows:

Router> enable

Password: <Enable Password>

Router# configure terminal

Router (config)# line vty <vty line #1> <vty line #2>

Router (config-line)# password <Telnet Password>

Router (config-line)# login

Router (config-line)# exit

Router (config)# exit

Router#

The preceding configuration assumes you have not configured user names in the Cisco IOS software.

Enabling Traps on the Device

EM traps should be enabled so that the router sends traps to the EM server at the appropriate IP address. To enable traps, proceed as follows:

Step 1 Telnet to the router and enter your login password.

Step 2 Enter the following:

enable

Step 3 Enter the enable password.

Step 4 Enter the following:

configure terminal

snmp-server enable traps

snmp-server host IP Address of EM server version 2c Community String of router

exit

To obtain help when using Cisco IOS commands, enter the command in question followed by a question mark.

Cisco Access Router Manager Installation Guide

2-8 OL-3598-02