Chapter 5 Getting Started
Starting a User Session
Starting a User Session
Starting the Cisco EMF manager system automatically starts the EM.
To start the Cisco EMF manager system, follow these steps.
Step 1 Ensure that Cisco EMF is running. For further information, see the “Checking the Status of the EM” section on page
Note If Cisco EMF is already started, proceed to step 4.
Step 2 Log in as a root user.
Step 3 Start the Cisco EMF manager system by entering the following:
CEMF_ROOT/bin/cemf start
(Replace CEMF_ROOT with the name of the directory where Cisco EMF is installed.) The Cisco EMF and EM processes start.
Any type of user (not only root users) can start a Cisco EMF user session.
Step 4 To start a Cisco EMF/EM user session, enter commands as follows:
CEMF_ROOT/bin/cemf session
(Replace CEMF_ROOT with the name of the directory where Cisco EMF is installed.)
Step 5 Enter a username and a password. (The default username is admin, and the default password is admin.)
Cisco Access Router Manager Installation Guide
|
| ||
|
|