Chapter 3 Upgrading an Installed EM
Upgrading the EM
[Press Enter to go to the UPGRADE main menu]
Step 4 Press Enter. The upgrade main menu is displayed.
UPGRADE PACKAGE
===============
1)CEMF Backup
2)Remove EM and related packages
3)Remove EM only (for multiple EM system)
4)Upgrade CEMF patch
5)Install new version of EM and related packages
6)One step upgrade automation (recommended for single EM system)
q)Quit
Which option do you wish to choose? [?,q]
Note While all of the major upgrade procedures are available as separate steps in the upgrade menu, it is recommended that you use the one step upgrade automation option (6) for a single EM system.
Tip Enter ? for help or q to quit.
Step 5 Choose the appropriate upgrade option. For this example, assume you have chosen option number 6 for one step upgrade automation. You are prompted to enter information needed to proceed with the upgrade, including:
•Whether or not to run Cisco EMF backup (not applicable for a client upgrade)
•If Cisco EMF backup is desired, whether the upgrade should continue if the backup fails (not applicable for a client upgrade)
•Location of the Cisco EMF patch
•Performance polling rate option for EM installation
Note An additional option to remove only the EM is available for a multiple EM system.
The following output is an example of the one step upgrade automation prompts:
Do you want to perform CEMF backup before the upgrade [YES]?
Should CEMF backup fail, would you want to continue with the upgrade [NO]?
Should
Enter the full path where
For CARMGRm installation -
Please choose from the following:
1)Use default interface polling rate for
2)Use EM customized interface polling rate for better performance.
Which option do you wish to choose? [ 1 2 ]: 1
Do you want to remove COMUpgd after upgrade [YES]?
Cisco Access Router Manager Installation Guide
|
| |
|
