Cisco Systems PA-2E3, PA-E3 manual Preparing for Installation, Parts and Tools Required

C H A P T E R 2

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing PA-E3 port adapters.

•

•

•

•

Parts and Tools Required, page 2-1

Software and Hardware Requirements, page 2-2

Safety Guidelines, page 2-3

Compliance Information, page 2-6

Parts and Tools Required

You need the following tools and parts to install a port adapter. If you need additional equipment, contact a service representative for ordering information.

•PA-E3 serial port adapter and one of the following:

—VIP2-15(=) if you are installing only one PA-E3 port adapter; otherwise, we recommend a VIP2-40(=) or VIP2-50(=).

—Catalyst RSM/VIP2-15(=) if you are installing only one PA-E3 port adapter; otherwise, we recommend a Catalyst RSM/VIP2-40(=).

—Cisco 7100 series router with at least one available port adapter slot.

—Cisco 7200 series router with at least one available port adapter slot.

—Cisco uBR7200 series router with at least one available port adapter slot.

•Cisco 75-ohm coaxial serial interface cables. (The PA-E3’s 75-ohm cables are available only from Cisco Systems; they are not available from outside commercial vendors.)

•Number 1 Phillips screwdriver and a 3/16-inch flat-blade screwdriver (for VIP2 and Catalyst RSM/VIP2 installation only).

•Your own ESD-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares.

Preparing for Installation 2-1