Cisco Systems PA-E3, PA-2E3 manual Port adapters

Removing a Port Adapter

Note The Cisco uBR7200 series routers support online Insertion and Removal (OIR); therefore, you do not have to power down the router when removing and replacing a PA-E3.

When a port adapter slot is not in use, blank port adapters must fill empty slots to allow the router to conform to EMI emissions requirements and to allow proper airflow across the port adapters. If you plan to install a new port adapter in a slot that is not in use, you must first remove the blank

port adapter.

Removing a Port Adapter

Following is the procedure for removing a port adapter from a Cisco uBR7200 series router:

Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.

Step 2 Unlock the port adapter retaining mechanism.

•For a Cisco uBR7246, place the port adapter retention clip for the desired port adapter slot in the unlocked position. The retention clip remains in the unlocked position. (See Figure 6-2.)

Figure 6-2 Placing the Port Adapter Retention Clip in the Unlocked

Position— Cisco uBR7246 Shown

Port adapters

H11518

Port adapter retention clip in unlocked position

6-2PA-E3 Serial Port Adapter Installation and Configuration