Cisco Systems PA-2E3, PA-E3 manual Port adapter retention clip in locked position

Installing a Port Adapter

Figure 6-6 Placing the Port Adapter Retention Clip in the Locked

Position— Cisco uBR7246 Shown

Port adapters

H11517

Port adapter retention clip in locked position

•For a Cisco uBR7223, place the port adapter lever in the locked position. (See Figure 6-7.)

Figure 6-7 Placing the Port Adapter Lever in the Locked

Position— Cisco uBR7223 Shown

Port adapters

Port adapter lever in locked position

16177

Note If the port adapter lever does not move to the locked position, the port adapter is not completely seated in the midplane. Carefully pull the port adapter halfway out of the slot, reinsert it, and move the port adapter lever to the locked position.

This completes the procedure for installing a port adapter in a Cisco uBR7200 series router. Proceed to Chapter 8, “Configuring the PA-E3 Interfaces,” for information on how to configure your

port adapter interfaces.

Cisco uBR7200 Series and the PA-E3 6-5