Cisco Systems PA-2E3, PA-E3 manual Installing a Port Adapter

Installing a Port Adapter

Figure 3-4 Pulling a Port Adapter Out of a Slot— Partial Port Adapter View

H3149

Step 7 If you removed a port adapter, place it in an antistatic container for safe storage or shipment back to the factory. If you removed a blank port adapter, no special handling is required; however, store the blank port adapter for potential future use.

This completes the procedure for removing a new port adapter on a VIP2.

Installing a Port Adapter

Following is the standard procedure for replacing a port adapter on the VIP2:

Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.

Step 2 Remove the new port adapter from its antistatic container and position it at the opening of the slot.

Step 3 Carefully align the port adapter carrier between the upper and the lower edges of the port adapter slot, as shown in Figure 3-5.

VIP2 and the PA-E3 3-5