Checking the Configuration
Following is an example of the show version command used with a Cisco 7500 series system:
router# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software, Version 11.1(16)CA
Synced to mainline version: 11.1(10.5)
Copyright (c)
Compiled Thu
Image
ROM: System Bootstrap, Version 5.3.2(3.2) [kmac 3.2], MAINTENANCE INTERIM SOFTWARE
ROM: GS Software, Version 11.1(8)CA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
keats uptime is 22 minutes System restarted by reload
System image file booted via tftp from 172.16.0.0
Last reset from
SuperLAT software (copyright 1990 by Meridian Technology Corp). Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant. TN3270 Emulation software (copyright 1994 by TGV Inc). Chassis Interface.
3 VIP2 controllers (1 FastEthernet)(4 Ethernet)(1 Fddi)(2 E3).
4 Ethernet/IEEE 802.3 interfaces.
1 FastEthernet/IEEE 802.3 interface.
2 Serial network interfaces.
1 FDDI network interface.
125K bytes of
8192K bytes of Flash internal SIMM (Sector size 256K). Configuration register is 0x2
To determine which type of port adapter is installed in your system, use the show diag slot command. Specific port adapter information is displayed, as shown in the following example of a
router# show diag 3
Slot 3:
E3 PA port adapter, | 1 | ports |
|
|
|
| |||
Port adapter is analyzed |
|
|
|
|
| ||||
Port adapter insertion | time 01:04:31 ago |
|
|
| |||||
Hardware revision 1.0 |
| Board revision UNKNOWN | |||||||
Serial number | 3710903 | Part number | |||||||
Test history | 0x0 |
| RMA number | ||||||
EEPROM format | version | 1 |
|
|
|
|
| ||
EEPROM contents (hex): |
|
|
|
|
|
| |||
0x20: 01 | 71 | 01 00 | 00 | 38 | 9F B7 49 07 | 09 | 03 00 00 00 | 00 | |
0x30: 06 00 | 00 00 | FF | FF FF 00 FF FF FF FF FF FF FF FF | ||||||
