Cisco Systems PA-2E3 manual 6PA-E3 Serial Port Adapter Installation and Configuration

Installing a Port Adapter

Figure 4-5 Port Adapter Installed in a Port Adapter Slot— Partial Port Adapter View

H3152

Step 5 Replace the screw in the rear of the port adapter slot. (See Figure 4-2 for its location.) Do not overtighten this screw.

Step 6 To reinstall the Catalyst RSM/VIP2 in the system, follow the steps in the Route Switch Module Catalyst VIP2-15 and VIP2-40 Installation and Configuration Note (Document Number 78-4780-01), which shipped with your Catalyst RSM/VIP2.

Step 7 If the interface cables have been disconnected, reconnect the interface cables to the port adapters.

This completes the procedure for installing a port adapter on a Catalyst RSM/VIP2. Proceed to Chapter 8, “Configuring the PA-E3 Interfaces,” for information on how to configure your port adapter interfaces.

4-6PA-E3 Serial Port Adapter Installation and Configuration