Cisco Systems PA-2E3, PA-E3 manual H3152

Installing a Port Adapter

Figure 3-6 Port Adapter Installed in a Port Adapter Slot— Partial Port Adapter View

H3152

Step 5 Replace the screw in the rear of the port adapter slot. (See Figure 3-3 for its location.) Do not overtighten this screw.

Step 6 To reinstall the VIP2 in the system, follow the steps in the section “Installing a VIP2” in the configuration note Second-Generation Versatile Interface Processor (VIP2) Installation and Configuration , which shipped with your VIP2.

Step 7 If the interface cables have been disconnected, reconnect the interface cables to the port adapters.

This completes the procedure for installing a port adapter on a VIP2. Proceed to Chapter 8, “Configuring the PA-E3 Interfaces,” for information on how to configure your port adapter interfaces.

VIP2 and the PA-E3 3-7