Cisco Systems CB21AG, PI21AG manual Bottom of Antenna Base

Chapter 3 Installing the Client Adapter

Inserting a Client Adapter

Follow the steps below to position the PCI card’s antenna on a flat horizontal surface or to mount it to a wall.

Step 1 Perform one of the following:

•If you want to use the antenna on a flat horizontal surface, position the antenna so it is pointing straight up. Then go to Step 7.

•If you want to mount the antenna to a wall, go to Step 2.

Step 2 Drill two holes in the wall that are 1.09 in. (2.8 cm) apart. Figure 3-5shows the distance between the mounting holes on the bottom of the antenna base.

Figure 3-5 Bottom of Antenna Base

1.09 inches

95597

Step 3 Tap the two supplied wall anchors into the holes.

Step 4 Drive the two supplied screws into the wall anchors, leaving a small gap between the screw head and the anchor.

Step 5 Position the mounting holes on the bottom of the antenna base over the screws (see Figure 3-6) and pull down to lock in place.

Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide

OL-4211-07 3-7