Chapter 4 | Advanced Configuration |
NOTE: The Local Security Group Type you select should match the Remote Security Group Type selected on the remote computer at the other end of the tunnel.
After you have selected the Local Security Group Type, the settings available on this screen may change, depending on which selection you have made.
IP
Only the computer with a specific IP address will be able to access the tunnel.
Local Security Group Type > IP
IP address Enter the appropriate IP address. The default IP is 192.168.1.0.
Subnet
The default is Subnet. All computers on the local subnet will be able to access the tunnel.
Local Security Group Type > Subnet
IP address Enter the IP address. The default is 192.168.1.0.
Subnet Mask Enter the subnet mask. The default is 255.255.255.0.
IP Range
Specify a range of IP addresses within a subnet that will be able to access the tunnel.
Local Security Group Type > IP Range
IP range Enter the range of IP addresses. The default is 192.168.1.0~254.
Remote Client Setup
Remote Client
Select the type you want to use: Domain Name(FQDN),
Domain Name(FQDN)
The default is Domain Name(FQDN).
Remote Client > Domain Name(FQDN)
Domain Name Enter the Fully Qualified Domain Name (FQDN), which is the host name and domain name for a specific computer on the Internet. When the remote computer requests to create a tunnel with the Router, the Router will work as a responder.
Remote Client >
Microsoft XP/2000 VPN Client
Dynamic IP users, such as PPPoE or DHCP users, who use the Microsoft VPN client software, can use this option. (The Microsoft VPN client software does not support Aggressive mode and FQDN or User FQDN ID options.)
Remote Client > Microsoft XP/2000 VPN Client
IPSec Setup
In order for any encryption to occur, the two ends of a VPN tunnel must agree on the methods of encryption, decryption, and authentication. This is done by sharing a key to the encryption code. For key management, the default mode is IKE with Preshared Key.
Keying Mode Select IKE with Preshared Key or Manual. Both ends of a VPN tunnel must use the same mode of key management. After you have selected the mode, the settings available on this screen may change, depending on the selection you have made. Follow the instructions for the mode you want to use. (Manual mode is available for VPN tunnels only, not group VPNs.)
IKE with Preshared Key
IKE is an Internet Key Exchange protocol used to negotiate key material for Security Association (SA). IKE uses the Preshared Key to authenticate the remote IKE peer.
Phase 1 DH Group Phase 1 is used to create the SA. DH
10/100 | 44 |
