6-18
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
OL-1520-05
Chapter6 Troubleshooting the System
Using Cable Interface debug Commands
debug cable map
To display map debugging messages, use the debug cable map command in privileged EXEC mode. Use
the no form of this command to disable debugging output.
debug cable map sid [sid-num]
no debug cable map
debug cable phy
To activate the debugging of messages generated in the cable PHY, use the debug cable phy command
in privileged EXEC mode. To deactivate the debugging of the cable PHY, use the no form of this
command.
debug cable phy
no debug cable phy
Cable PHY is the physical layer where upstream and downstream activity between the
CiscouBR10012router and the HFC network is controlled. When this command is activated, messages
generated in the cable PHY are displayed on the CiscouBR10012router console.
debug cable privacy (for Baseline Privacy)
To activate the debugging of baseline privacy, use the debug cable privacy command in privileged
EXEC mode. To disable debugging output, use the no form of this command.
debug cable privacy
no debug cable privacy
debug cable qos
To activate the debugging of QoS, use the debug cable qos command in privileged EXEC mode. To
deactivate debugging of QoS, use the no form of this command.
debug cable qos
no debug cable qos
When this command is activated, messages related to QoS parameters are displayed on the
CiscouBR10012router console.
debug cable range (for Ranging Messages)
To activate the debugging of ranging messages from cableinterfaces on the HFC network, use the
debugcablerange command in privileged EXEC mode. To deactivate debugging of cableinterface
ranging, use the no form of this command.
debug cable range
no debug cable range
When this command is activated, ranging messages generated when cableinterfaces request or change
their upstream frequencies are displayed on the CiscouBR10012router console.