B-14

AppendixB Configuration Register Information for the CiscouBR10012 Universal Broadband Router
Displaying the Configuration Register While Running ROM Monitor
Last reset from power-on
Toaster processor tmc0 is running.
Toaster processor tmc1 is running.
1 OC12 POS controller (1 POS)
1 TCCplus card(s)
1 FastEthernet/IEEE 802.3 interface(s)
1 Gigabit Ethernet/IEEE 802.3 interface(s)
3 Packet over SONET network interface(s)
2 Cable Modem network interface(s)
509K bytes of non-volatile configuration memory.
46976K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
32768K bytes of Flash internal SIMM (Sector size 256KB).
Configuration register is 0x0
Router#
Displaying the Configuration Register While Running ROM Monitor

If the bootstrap prompt “>”, the o command displays the virtual configuration register currently in effect.

It includes a description of the bits. See the following sample output:

>o
Configuration register + 02x100 at last boot
Bit# Configuration register option settings:
15Diagnostic mode disabled
14IP broadcasts do not have network numbers
13Boot default ROM software if network boot fails
12-11Console speed is 9600 baud
10IP broadcasts with ones
09Do not use secondary bootstrap
08Break disabled
07OEM disabled
06Ignore configuration disabled
05Fast boot disabled
04Fan boot disabled
03-00Boot to ROM monitor

If the prompt is “rommon1”, the confreg command displays the virtual configuration register currently

in effect. It includes a description of the bits. See the following sample output:

rommon 1 > confreg
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: the ROM Monitor
Do you wish to change the configuration? y/n [n]