Cisco Systems UBR10012 - page 93

1-73
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
OL-1520-08
Chapter1 Overview of CiscouBR10012 Universal Broadband Router Software Supported Software Features for the CiscouBR10012 Router
Command Modes Global configuration mode
Command History
Usage Guidelines The pre-equalization exclusion feature should be configured for the running configuration of the
Network Processing Engine (NPE), the Performance Routing Engine (PRE), and the line card console.
Examples The following example configures pre-equalization to be excluded for the specified cable modem.
Pre-equalization data is not sent for the corresponding cable modem:
Router(config)# cable pre-equalization exclude modem mac-addr
The following example configures pre-equalization to be excluded for the specified OUI value of the
entire interface. Pre-equalization data is not sent for the corresponding OUI value of the entire interface:
Router(config)# cable pre-equalization exclude oui mac-addr
The following series of commands configures pre-equalization on the Cisco uBR10012 router with
MC5X20U BPEs. On the PRE Console, configure the following commands.
Router# conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# cable pre-equalization exclude oui 00.09.04
Router(config)# end
Router# show run
Router# show running-config | inc oui
cable pre-equalization exclude oui 00.09.04
Router#
On the line card console for the same Cisco uBR10012 router, verify the configuration with the
following command:
clc_7_1# show running-config | inc oui
cable pre-equalization exclude oui 00.09.04
clc_7_1#
The following series of commands configures pre-equalization on the Cisco uBR72436VXR router with
MC28U cable interface line cards. On the Network Processing Engine (NPE) console, configure and
verify with the following commands.
npeg1-test# conf t
Enter configuration commands, one per line. End with CNTL/Z.
npeg1-test(config)# cable pre-equalization exclude oui 00.09.24
npeg1-test(config)# end
npeg1-test#show ru
02:58:10: %SYS-5-CONFIG_I: Configured from console by consolen
npeg1-test# show running-config | inc oui
cable pre-equalization exclude oui 00.09.24
npeg1-test#
On the line card console for the same Cisco uBR7246VXR router, verify the configuration with the
following command:
Release Modification
12.3(17a)BC This command was introduced to the Cisco uBR10012 router and the Cisco
uBR7246VXR router.