1-60
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
OL-1520-08
Chapter1 Overview of CiscouBR10012 Universal Broadband Router Software
Supported Software Features for the CiscouBR10012 Router
set ip tos value
show route-map [map-tag]
For more information on PBR, refer to the "Configuring Policy-Based Routing" chapter in the Cisco IOS
Quality of Service Solutions Configuration Guide, Release 12.2 at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt1/qcfpbr.htm

Supported Protocols

The CiscouBR10012router supports multiple protocols of multiple classes, including but not limited
to, the following:
Address Resolution Protocol (ARP)
Cisco Discovery Protocol (CDP)
Domain Name System (DNS)
Internet Protocol (IP) v4/v5
Simple Network Management Protocol (SNMP) v2 and SNMPv3 Integrated Dynamic Host
Configuration Protocol (DHCP) server
Trivial File Transfer Protocol (TFTP) client
User Datagram Protocol (UDP)
Note Be aware that when configuring a routing protocol, the Cisco IOS software must reset the interfaces to
enable the change. This normally does not significantly affect operations on the interface, except that
when this is done on a cable interface, it causes all cable modems on that particular downstream to
reinitialize, potentially interfering with data transmission on that downstream. Therefore, you should use
routing global configuration commands, such as router rip, on a cable interface only when a minimum
of subscribers would be affected.
For additional information about configuring IP routing protocols, refer to the IP Routing Protocols”
chapter in the Cisco IOS IP Configuration Guide, Release 12.2 on Cisco.com.
Management Features
The CiscouBR10012router provides you with the following features that make CMTS headend
configuration, management, and DOCSIS support more powerful and efficient:
Admission Control for the Cisco CMTS
Broadband Internet Access
Cable Interface Bundling
CNEM Compliance
Customer Premises Equipment Limitation and Override
DOCSIS 2.0 SAMIS ECR Data Set
DOCSIS Set-Top Gateway Issue 1.0
Advanced-mode DOCSIS Set-Top Gateway Issue 1.1
Downstream Channel ID Configuration
Downstream Frequency Override
Dynamic Channel Change (DCC) for Loadbalancing
Dynamic Modulation Profiles
Dynamic Upstream Modulation