Cisco Systems WMA11B manual Instructions, Move the Adapter and its power adapter to the TV

Wireless-B Media Adapter

Chapter 5: Connecting the Wireless-B Media Adapter to Your TV and Stereo

Overview

This chapter will explain what to do if you used the Setup Wizard to set up the Adapter and what to do if you want to set up the Adapter from your TV.

If you used the Setup Wizard, then follow the instructions to disconnect the Adapter from your network, connect the Adapter to your TV (and stereo, if you have one), and re-connect the Adapter to your network. (You have to disconnect the Adapter from your network in order to move it to your TV and stereo.)

If you want to set up the Adapter from your TV, then go directly to the “Connecting to Your TV and Stereo” section if you have a stereo. Go directly to the “Connecting to Your TV Only” section if you do not have a stereo.

Instructions

1. Press the Adapter’s power button on its front panel to power it off.

Note: Make sure you keep the PC you were using powered on because it will communicate with the	Figure 5-1: Unplug the Power
Adapter and send music and pictures.

2.Unplug the power adapter from the Adapter’s Power port and electrical outlet. See Figure 5-1.

3.If you used a wired computer to set up the Adapter, then unplug the Ethernet network cable from the Adapter’s LAN port and the Ethernet (LAN) port of your PC, router, or switch.

4.Move the Adapter and its power adapter to the TV.

5.If you have a stereo, go to the “Connecting to Your TV and Stereo” section. If you do not have a stereo, go to the “Connecting to Your TV Only” section.

Chapter 5: Connecting the Wireless-B Media Adapter to Your TV and Stereo 18

Overview