Juniper Networks G10 CMTS manual Connect to Power Sources

G10 CMTS Installation Checklist

•	Step	Page Number	Completion Status
•
	Connect to Power Sources
•
•	Ensure that each power distribution rocker switch is OFF (AC only)	page 119
•
	Plug each power cord into the power receptacles (AC) or terminal blocks (DC)
•
	Close the retainer clips around the power cords (AC) or secure the DC ring lugs to the
•
	terminal blocks (DC)
•
	Plug the other ends of the power cords to their respective, independent power sources
•
•	Power On the G10 CMTS
•	Ensure that the power sources are on	page 123
•
	Turn on the power switches on the power transition modules (AC only)
•
	Check all power supply LEDs (power supply faceplate must be removed, then replaced)
•
•	Check front and rear fan tray LEDs
•
	Check all DOCSIS Module LEDs
•
	Check all Chassis Control Module LEDs
•
	Check all NIC Module LEDs
•
•	Power On and Configure the PC
•
	Power on the PC, launch the asynchronous terminal emulation application, and	page 127
•
	establish a direct serial connection with the Chassis Control Module
•
	Check for correct boot banner and system prompt on PC
•
	Log into the G10 CMTS
•
•	Perform Initial Software Configuration
•	Configure the name of the CMTS	page 128
•
	Configure the CMTS’s domain name
•
	Configure the IP address of the Fast Ethernet management port
•
•	Configure the IP address of a backup router
•
	Configure the IP address of a DNS server
•
	Set the root authentication password
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

92 JUNOSg 3.0 G10 CMTS Hardware Guide