Juniper Networks G10 CMTS manual G10 Cmts Management, G10 Cmts Hardware Overview

G10 CMTS Management

•G10 CMTS Management

•
•	The G10 CMTS supports the following system management applications and tools:
•
•	! Command-Line Interface (CLI)—The CLI provides the most comprehensive controls and
•	is instrumental for installation, configuration, troubleshooting, and upgrade tasks.
•
•	! SNMP—The CMTS can interact with SNMPv2c and SNMPv3-based Network
•	Management Systems using DOCSIS 1.0 and DOCSIS 1.1 MIBs and enterprise MIBs.
•	Events can conditionally be reported as system log messages or SNMP traps.
•
•	! ServiceGuard Management System – This optional advanced diagnostics application
•	with a Java GUI provides a rendition of a spectrum analyzer for acquiring data on
•	upstream transmission cable performance. It incorporates an integrated Impairment
•	Identification tool that allows for unattended monitoring of statistics to characterize
•	compromised performance to a potential cause (such as impulse or burst noise, narrow
•	band ingress, or microreflections).
•
•

•G10 CMTS Hardware Overview

•
•	This section provides an overview of the modules and various hardware components of the
•
	G10 CMTS and where they reside within the chassis. This overview presents material that is
•
	specific to the installation and configuration of the G10 CMTS.
•
•	Figure 4 on page 11 illustrates a front view of a fully configured chassis. Figure 5 on page 12
•
	illustrates a front view of a partially configured chassis in which DOCSIS Modules, a Chassis
•
	Control Module (CCM), a Network Interface Card (NIC) Module, power supplies, air
•
	management modules, and power supply filler panels have been removed. Figure 6 on
•
	page 13 illustrates a rear view of a fully configured chassis that uses the AC power transition
•
	module and HFC Connector Modules (see Figure 39 on page 122 for an illustration of the DC
•
	power transition module). Figure 7 on page 14 illustrates the rear view of the partially
•
	configured chassis in which HFC Connector Modules, a Hard Disk Module, a NIC Access
•
	Module, and air management panels have been removed. Figure 8 on page 15 provides a top
•
	view of the chassis midplane showing the slot numbering and the location of each module.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

10 JUNOSg 3.0 G10 CMTS Hardware Guide