Juniper Networks G10 CMTS manual Verification of Shipping Cartons

Verification of Shipping Cartons

Table 37: Downstream CMTS Parameter Characterization

Downstream Parameters	Port 0	Port 1	Port 2	Port 3
DOCSIS Module #___
Node combining ratio per port	____ : 1	____ : 1	____ : 1	____ : 1
Interface frequency allocated	____ MHz	____ MHz	____ MHz	____ MHz
Modulation type	_ 64QAM _256QAM	_ 64QAM _256QAM	_ 64QAM _256QAM	_ 64QAM _256QAM
Output signal level (relative to analog	____ dB	____ dB	____ dB	____ dB
video)
Required interface output level	____ dBmV	____ dBmV	____ dBmV	____ dBmV
Interleave depth setting	___ [I] (# of taps)	___ [I] (# of taps)	___ [I] (# of taps)	___ [I] (# of taps)
	___ [J] (increments)	___ [J] (increments)	___ [J] (increments)	___ [J] (increments)

Verification of Shipping Cartons

Prior to beginning the installation of the G10 CMTS, you should verify that the contents of the shipping cartons are identical to the contents listed on the packing lists. In addition, you should carefully inspect the shipped contents to ensure that they are not damaged in any manner. If any contents are missing or damaged, report this to customer support.

To verify the contents of the shipping cartons match the packing list, use the following procedure:

1.Carefully open the shipping cartons. Pay attention to any instructions printed on each shipping carton.

2.Remove all the contents of the shipping cartons. When lifting heavy contents, be sure to follow the safety precautions listed in “Safety Precautions” on page 68.

3.Verify that the contents of the shipping cartons are identical to the contents listed on the packing lists.

4.Verify that the correct number of power supplies are installed in the G10 CMTS chassis.

5.Open all accessory kits that are included in the shipment. Verify that the contents are identical to the contents listed on the accessory kit packing lists.

6.Install the power supply faceplate included in the shipment by aligning its four ball studs with the four power supply faceplate clips and pressing the faceplate towards the chassis until it snaps into place. If you will install additional power supplies, this step can be deferred.

You must install the power supply faceplate prior to powering on the G10 CMTS to ensure that proper air ventilation occurs throughout the chassis.

7.Install the air intake faceplate included in the shipment by aligning its four ball studs with the four air intake faceplate clips and pressing the faceplate towards the chassis until it snaps into place.

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

Prepare the Site 89