Juniper Networks G10 CMTS manual Tools and Equipment Required for Installation

Tools and Equipment Required for Installation

•Tools and Equipment Required for Installation

•
•	You need the following tools to complete the G10 CMTS installation:
•
•	! M2.5 Phillips torque screwdriver
•
•	! M2.5 flathead torque screwdriver
•
•	! M3 Phillips torque screwdriver
•
•	! M5 Phillips torque screwdriver
•
•	! #10 Phillips torque screwdriver
•
•	! #10 flathead torque screwdriver
•
•	! #12 Phillips torque screwdriver
•
•	! 7/16 in. torque wrench
•
•	! 22-10 AWG crimper/cutter/stripper
•
•	In addition, you might need the following supplies:
•
•	! RF cables and adapters
•
•	! Ethernet cables with RJ-45 connectors
•
•	You need the following equipment to configure the G10 CMTS and verify that the RF system
•	has been set up properly:
•
•	! PC with asynchronous terminal emulation
•
•	! RF spectrum analyzer
•
•	! RF power meter
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

74 JUNOSg 3.0 G10 CMTS Hardware Guide